TY - GEN A1 - Penkov, Igor A1 - Aleksandrov, Dmitri A2 - Jurczak, Paweł - red. PB - Zielona Góra: Uniwersytet Zielonogórski N2 - The article discusses ways for optimization of a standard nozzle cup design to achieve a narrower paint flow. The analysis of a standard nozzle cup shows that distribution of air pressure is critically uneven both along the nozzle axis and in the radial direction. A decrease in pressure is about 45% at the distance of 2 mm from the front surface of the nozzle cup. N2 - Air pressure decreases about 40% at the distance of 2 mm from the nozzle axis in the radial direction. Air velocity decreases about 52% at the distance of 4 mm from nozzle surface but then the velocity stabilizes and decreases is about 59% at the distance of 10 mm from the nozzle surface in comparison to its magnitude on the nozzle surface. N2 - Six extra holes and a circular rim were added to the standard nozzle cup to obtain paint stream as narrow as possible. Also was modified inner surface of the nuzzle cup. Totally, four different components were analysed. The results show that with increasing the nozzle cone by fifteen or more degrees, the pressure distribution decreases. N2 - Most optimal solution has six small holes around the nozzle hole and a small rim covering all holes. In this case, pressure decreases only 3% in the axial direction and 4% in the radial direction at the distance of 2 mm from the front surface of the nozzle. Distribution of air velocity is still significant but its magnitude is about 35% ? 45% less than at the standard nozzle cup. L1 - http://www.zbc.uz.zgora.pl/Content/70994/10.2478_ijame-2020-0060.pdf L2 - http://www.zbc.uz.zgora.pl/Content/70994 KW - fluid flow simulation KW - nozzle geometry KW - optimization T1 - Influence of nozzle geometry on fluid flow parameters UR - http://www.zbc.uz.zgora.pl/dlibra/docmetadata?id=70994 ER -